If you have been reading about mass spectrometry and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Last reviewed on 2026-05-02. Where a claim depends on a specific study, the study is described rather than over-claimed.
Common degradation pathways include oxidation of the methionine side chain, hydrolysis of the peptide backbone, and aggregation under unfavourable pH or concentration. Stability studies typically monitor the main peak by chromatography and report total related substances as a percentage. Because no official monograph exists, acceptance criteria vary between laboratories, and reported purity values are not directly comparable across suppliers. Analysts therefore document the method, column, and detection wavelength alongside each result, and open questions remain about how much biological activity the oxidised forms retain.
Solid semax is typically supplied as a lyophilised powder that is hygroscopic and sensitive to moisture, light, and repeated temperature cycling. Long-term storage of the dry peptide is generally recommended at approximately -20 degrees Celsius, while shorter working periods may use refrigeration at 2 to 8 degrees Celsius. Vials should remain tightly closed and desiccated when brought to room temperature, because condensation can damage the material before it is weighed. Dividing a batch into aliquots is preferable to thawing one container repeatedly.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
| Property | Value | Notes |
|---|---|---|
| Typical analytical method | Reversed-phase HPLC with UV detection | Separates target peptide from truncated and oxidised forms |
| Identity confirmation | LC-MS or ESI-MS | Compares observed and calculated molecular ion |
| Primary degradation route | Methionine oxidation | Forms the sulfoxide; monitored as an early-eluting peak |
| Short-term storage | 2 to 8 degrees Celsius | Applies to working vials and reconstituted portions |
| Common synonyms | ACTH(4–10) analogue, MEHFPGP | Descriptive names used in laboratory catalogues |
Lyophilized material is chemically stable for extended periods when kept dry, cold, and protected from light. The powder is hygroscopic, so vials should be warmed to room temperature before opening to reduce condensation on the contents. Once dissolved, the peptide is far less stable because peptide bonds are susceptible to hydrolysis and the methionine residue can oxidize. Solutions are typically aliquoted and held at 2-8 °C for short intervals or frozen for longer ones, and repeated freeze-thaw cycles should be avoided.
Routine characterization relies on reversed-phase high-performance liquid chromatography to establish purity and on mass spectrometry to confirm molecular identity. Electrospray ionization and matrix-assisted laser desorption ionization are both used for mass verification. Amino acid analysis and peptide mapping can detect sequence errors. Common impurities include truncated sequences, methionine sulfoxide formed by oxidation, and deamidated products. Chromatograms are usually recorded near 214 nm, where the peptide backbone absorbs, and purity is reported as the percentage area of the principal peak.
Verification of a supplied batch generally combines a certificate of analysis with independent testing, because certificates are self-reported documents. A typical package includes a chromatographic trace, a mass spectrum, and a stated water or counter-ion content. Batch-to-batch consistency matters more than a single purity figure when results are compared across experiments. No single mandatory standard governs research-grade peptide release, so laboratories are expected to define their own acceptance criteria. Residual trifluoroacetate from purification is a frequently overlooked counter-ion.
从分子层面看，Semax 是线性七肽，没有二硫键、糖基或脂链修饰，N 端为游离氨基，C 端为游离羧基。分子含组氨酸与谷氨酸侧链，因此在水和甲醇等极性溶剂中溶解良好，在非极性溶剂中溶解有限。计算分子量约为 814 Da，与其质子化离子的质荷比吻合，可用于质谱确认。
稳定性主要由水解与氧化两条路径支配。肽键在中性或弱酸性条件下相对稳定，遇到强碱或长时间高温则明显断裂；甲硫氨酸侧链容易被氧化成亚砜，使主峰前移并拉低实际含量。金属离子、光照和反复冻融会进一步促进降解或聚集。冻干粉在低温避光条件下可存放较长时间，配制后的水溶液通常需要冷藏并尽快用完。
纯度评估以反相高效液相色谱为主，通过主峰面积百分比给出粗略结果，再配合电喷雾质谱核对分子量。氨基酸分析可验证组成比例，手性色谱或毛细管电泳用于检查残基构型。常见杂质包括缺失序列的短肽、氧化产物与二聚体。由于多数市售品不附带完整检验报告，独立第三方检测常被用来核实标称值。
The reactions that produce, consume, and regenerate SAM are called the SAM cycle. In the first step of this cycle, the SAM-dependent methylases (EC 2.1.1) that use SAM as a substrate produce S-adenosyl homocysteine as a product. S-Adenosyl homocysteine is a strong negative regulator of nearly all SAM-dependent methylases despite their biological diversity. The S-adenosyl homocysteine is hydrolysed to homocysteine and adenosine by S-adenosylhomocysteine hydrolase and the homocysteine recycled back to methionine through transfer of a methyl group from 5-methyltetrahydrofolate, by one of the two classes of methionine synthases (i.e. cobalamin-dependent or cobalamin-independent). This methionine can then be converted back to SAM, completing the cycle. In the rate-limiting step of the SAM cycle, MTHFR (methylenetetrahydrofolate reductase) irreversibly reduces 5,10-methylenetetrahydrofolate to 5-methyltetrahydrofolate.
=== Effect of polymorphisms === Certain polymorphisms in the ABCC1 gene have been shown to be connected with an increased susceptibility to certain types of cancer. A G2168A polymorphism and polymorphisms found in the 3'-UTR region of the gene have been shown to have a connection with increased susceptibility to lung cancer, especially in Chinese populations. Carriers of the G2168A polymorphism contract lung cancer at a rate nearly four times higher than those individuals that do not have the mutation in the gene. Polymorphisms within the ABCC1 gene also tend to have a substantial effect on the severity of a disease. Examples of these diseases includes cystic fibrosis (CF) and chronic obstructive pulmonary disease (COPD). In reference to cystic fibrosis, individuals with a G-260C polymorphism in the 5'-UTR area of the ABCC1 gene tended to have a much more severe case of cystic fibrosis than individuals with the wild-type gene. Individuals with chronic obstructive pulmonary disorder were impacted by two polymorphisms in the ABCC1 gene. If an individual had a 3'-UTR T866A polymorphism, they generally had a less severe case of COPD marked by less inflammation in their airways. On the other hand, an individual with a 3'-UTR G3361A polymorphism generally had a more severe case of COPD that was accompanied by a greater amount of inflammation in their airways.
=== Pharmacokinetics === A small amount of rimexolone is absorbed into the systemic circulation. On hourly treatment with the eye drops for a week, blood serum concentrations peaked at 150 pg/ml on average, with many patients remaining below the detection threshold of 80 pg/ml. The elimination half-life from the circulation is estimated at one to two hours; the substance is mainly (over 80%) excreted via the faeces.
=== Stem cells === There is a bioengineering technique that uses stem cells to create corneas or part of corneas that can be transplanted into the eyes. Corneal stem cells are removed from a healthy cornea. They are collected and, through laboratory procedures, made into five to ten layers of cells that can be stitched into a patient's eye. The stem cells are placed into the area where the damaged cornea tissue has been removed. This is a good alternative for those that cannot gain vision through regular cornea transplants. A new development, announced by the University of Cincinnati Medical School in May 2007, would use bone marrow stem cells to regrow the cornea and its cells. This technique, which proved successful in mouse trials, would be of use to those with inherited genetic degenerative conditions of the cornea, especially if other means like a transplant are not feasible. It works better than a transplant because these stem cells keep their ability to differentiate and replicate, and so keep the disease from recurring, longer and better.
Sources: en.wikipedia.org
Agile Manufacturing is a modern production approach that enables companies to respond swiftly and flexibly to market changes while maintaining quality and cost control. This methodology is designed to create systems that can adapt dynamically to changing customer demands and external factors such as market trends or supply chain disruptions. It is mostly related to lean manufacturing. While Lean Manufacturing focuses primarily on minimizing waste and increasing efficiency, Agile Manufacturing emphasizes adaptability and proactive responses to change. The two approaches are complementary and can be combined into a “leagile” system, which balances cost efficiency with flexibility. The principles of Agile Manufacturing, with its focus on flexibility, responsiveness to change, collaboration, and delivering customer value, serve as a foundation for the later development of Agile Software Development.
Ca2+ + 2 HCO−3 → CaCO3↓ + CO2 + H2O At seawater pH, most of the dissolved CO2 is immediately converted back into HCO−3. The reaction results in a net transport of one molecule of CO2 from the ocean/atmosphere into the lithosphere. The result is that each Ca2+ ion released by chemical weathering ultimately removes one CO2 molecule from the surficial system (atmosphere, ocean, soil and living organisms), storing it in carbonate rocks where it is likely to stay for hundreds of millions of years. The weathering of calcium from rocks thus scrubs CO2 from the ocean and air, exerting a strong long-term effect on climate.
== Contraindications == The US approval lists the thyroid C cell cancers medullary thyroid carcinoma (MTC) and multiple endocrine neoplasia type 2 (MEN 2) as contraindications because other GLP-1 agonists are known to cause such cancers in rodents. Albiglutide causes immunogenicity in rodents, so its cancer risk could not be assessed. The European approval mentions the uncertainty about C cell cancers, but not as a contraindication.
Sources: en.wikipedia.org
== Diketopiperazines (cyclic dipeptides) == Diketopiperazines are a special class of dipeptides, which are cyclic. They form as side products in peptide synthesis. Many have been produced from non-canonical amino acids.
The most frequent sign of Peyronie's disease is penile curvature acquired on erection. The location and extent of curvature vary with the location and extent of the fibrous plaque of the tunica albuginea. Curvature is the most frequent complaint, but some men complain of penile shortening, penile narrowing (hourglass deformity), or indentations. Palpable plaques can be seen along the shaft, most commonly on the dorsum. Pain with erection is common during the initial, inflammatory phase but usually resolves during the chronic phase with resolution of swelling. Erectile dysfunction is estimated to affect 30–70% of men with Peyronie's disease, either due to decreased rigidity secondary to anatomic changes or psychogenic causes like distress and sexual performance anxiety. Peyronie's disease can substantially impair sexual function and quality of life, leading to depression, relationship difficulties, and low self-esteem.
Hemostasis is a natural mechanism for minimizing blood loss due to vessel damage while ensuring adequate blood circulation in the organism under Physiologically normal conditions. Platelet adhesion to the exposed collagen due to the action of integrin α2β1 is one of the mechanisms of primary hemostasis. In the state of physiological health, collagen is present below the endothelium and is not accessible to platelets circulating in the blood stream. The damage to the walls of the vessel makes collagen accessible for the platelets and allows them to adhere to collagen fibers due to the activity of platelet collagen receptors, such as α2β1 integrin and GPVI. In contrast to the GPVI functioning as a signaling receptor, α2β1 mainly provides the stabilization of the platelet adhesion to the collagen and facilitates their stable fixation on the damaged area. This process is especially necessary in case of high shear stresses in the arteries due to the negative impact of the blood flow force on platelets' fixation. The enhanced adhesion allows attracting more platelets and forming a stable thrombus that is capable of minimizing blood loss.
Sources: en.wikipedia.org
Dry powder is usually kept at about -20 degrees Celsius for long-term storage and at 2 to 8 degrees Celsius for short working periods. Containers should stay sealed and protected from light and moisture to limit degradation.
Oxidation of the methionine residue to the sulfoxide is a frequently reported change, and it usually appears as an earlier-eluting peak in reversed-phase chromatography. Backbone hydrolysis products can also accumulate in aqueous solution.
Liquid chromatography coupled with mass spectrometry is the usual approach, because the observed molecular ion can be compared with a calculated mass of about 813.9 Da. Retention time alone does not establish identity.
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.